Holden Statesman Wiper Blades Size Guide

The Holden Statesman is a full-size luxury sedan produced by Holden, positioned below the flagship Caprice and above the Berlina in the Commodore-based range. The Statesman nameplate ran from 1990 through to 2010 when it was discontinued after the WM series. Wiper blade sizes vary by series: VQ, VR and VS models (1990–1999) use a 20 inch (500mm) blade on both sides; WH, WK and WL models (1999–2006) use a 22 inch (550mm) driver blade and a 20 inch (500mm) passenger blade; WM models (2006–2010) use a 26 inch (650mm) driver blade and a 15 inch (375mm) passenger blade. VQ, VR, VS, WH, WK and WL models use a J-Hook connector; WM models use a Pinch Tab connector. No Statesman variant is fitted with a rear wiper blade. Find your vehicle year in the table below.

Sedan (VQ VR VS)

Sedan (WH WK WL)

Sedan (WM)

Frequently Asked Questions

What size wiper blades does a Holden Statesman take?

The Holden Statesman wiper blade size depends on the series. VQ, VR and VS models (1990–1999) use a 20 inch (500mm) blade on both the driver and passenger sides. WH, WK and WL models (1999–2006) use a 22 inch (550mm) driver blade and a 20 inch (500mm) passenger blade. WM models (2006–2010) use a 26 inch (650mm) driver blade and a 15 inch (375mm) passenger blade.

Does the Holden Statesman have a rear wiper?

No, the Holden Statesman does not have a rear wiper blade. This model is a sedan-only lineup across all series and is fitted with two front wiper blades only, which can be confirmed in the specifications on the product pages.

What wiper connector does the Holden Statesman use?

VQ, VR and VS models (1990–1999) and WH, WK and WL models (1999–2006) use a J-Hook connector on the front wiper arms. WM models (2006–2010) use a Pinch Tab connector, the same type used on the VE Commodore platform the WM Statesman is based on. All replacement blades available through this site come with the correct adaptor included.

When was the Holden Statesman discontinued?

The Holden Statesman was discontinued in September 2010 after the WM series ended. The Statesman nameplate was not carried over to the WN generation; that model was sold only as the Caprice. Owners of 2010 WM Statesmans should use the WM Statesman specifications when purchasing replacement wiper blades.

How often should I replace Holden Statesman wiper blades?

Holden Statesman wiper blades should be replaced every 12 months, or sooner if streaking, smearing or skipping is noticed during use. Rubber compounds in wiper blades degrade over time from UV exposure and heat, both of which are particularly intense in the Australian climate. Replacing both blades as a pair ensures even wiping pressure and consistent windscreen coverage.

Browse all Holden Statesman wiper blades, return to the Holden wiper blades page, or visit our wiper blades size guide for all makes and models.