The Toyota Coaster is a light bus used widely across Australia for school, community and commercial transport. The Coaster takes a 22 inch (550mm) blade on both the driver and passenger side on the later HZB50 HZB51 BB50 generation, while the earlier generation uses a 20 inch (500mm) blade on both sides. Front wipers use a J-Hook connector across both generations, and the model does not have a rear wiper. Find your vehicle year in the table below.

Bus (BB40 HZB30 HDB30 HB31 HB30 BB21 BB22 BB23)

Year Driver Side Passenger Side Buy and Save 50% Off RRP
1984 20" (500mm) 20" (500mm) Buy Now
1985 20" (500mm) 20" (500mm) Buy Now
1986 20" (500mm) 20" (500mm) Buy Now
1987 20" (500mm) 20" (500mm) Buy Now
1988 20" (500mm) 20" (500mm) Buy Now
1989 20" (500mm) 20" (500mm) Buy Now
1990 20" (500mm) 20" (500mm) Buy Now
1991 20" (500mm) 20" (500mm) Buy Now
1992 20" (500mm) 20" (500mm) Buy Now
1993 20" (500mm) 20" (500mm) Buy Now
1994 20" (500mm) 20" (500mm) Buy Now
1995 20" (500mm) 20" (500mm) Buy Now
1996 20" (500mm) 20" (500mm) Buy Now
1997 20" (500mm) 20" (500mm) Buy Now
1998 20" (500mm) 20" (500mm) Buy Now
1999 20" (500mm) 20" (500mm) Buy Now
2000 20" (500mm) 20" (500mm) Buy Now

Bus (HZB50 HZB51 BB50)

Year Driver Side Passenger Side Buy and Save 50% Off RRP
2001 22" (550mm) 22" (550mm) Buy Now
2002 22" (550mm) 22" (550mm) Buy Now
2003 22" (550mm) 22" (550mm) Buy Now
2004 22" (550mm) 22" (550mm) Buy Now
2005 22" (550mm) 22" (550mm) Buy Now
2006 22" (550mm) 22" (550mm) Buy Now
2007 22" (550mm) 22" (550mm) Buy Now
2008 22" (550mm) 22" (550mm) Buy Now
2009 22" (550mm) 22" (550mm) Buy Now
2010 22" (550mm) 22" (550mm) Buy Now
2011 22" (550mm) 22" (550mm) Buy Now
2012 22" (550mm) 22" (550mm) Buy Now
2013 22" (550mm) 22" (550mm) Buy Now
2014 22" (550mm) 22" (550mm) Buy Now
2015 22" (550mm) 22" (550mm) Buy Now
2016 22" (550mm) 22" (550mm) Buy Now

Frequently Asked Questions

What size wiper blades does a Toyota Coaster take?

The Toyota Coaster takes a 22 inch (550mm) blade on both the driver and passenger side on the 2001 to 2016 HZB50 HZB51 BB50 generation. The earlier 1984 to 2000 generation uses a smaller 20 inch (500mm) blade on both sides. Owners should check their build year against the table above to confirm the correct fitment.

Does the Toyota Coaster have a rear wiper?

No, the Toyota Coaster does not have a rear wiper blade across either generation covered here. This model is fitted with two front wiper blades only, which can be confirmed in the specifications on the product page.

What wiper connector does the Toyota Coaster use?

The Toyota Coaster uses a J-Hook connector on the front wipers across both generations. This makes fitment straightforward regardless of which body code applies to the vehicle. The connector clips directly onto the factory wiper arm without modification.

Why does the Toyota Coaster use the same size on both sides?

Unlike most passenger vehicles, the Toyota Coaster uses matching blade sizes on the driver and passenger side because of its flat, symmetrical bus windscreen. This means a single size covers both positions on each generation, simplifying spares for fleet operators running multiple Coasters. Always confirm the build year before ordering, since the two generations use different sizes.

How often should I replace Toyota Coaster wiper blades?

Wiper blades on a Toyota Coaster should generally be replaced every 6 to 12 months, or sooner for vehicles used in commercial or school transport with higher daily use. Buses that spend long periods parked outdoors are prone to faster rubber perishing from UV exposure. Regular checks help maintain clear visibility for drivers responsible for passengers.

Browse all Toyota Coaster wiper blades, return to the Toyota wiper blades page, or visit our wiper blades size guide for all makes and models.